DS Produkte PC-P002W-2 Mode D'emploi page 23

■ Test the wiping cloth on a non-visible spot before using it on sensitive (high-gloss)
surfaces.
■ Do not use the device when it is connected to the mains adapter.
1. Insert the suction nozzle you want into the suction opening and make sure that all
of the remaining parts are attached to the device correctly (see the "Collecting Con-
tainer" chapter).
Cleaning Windows and Other Smooth Surfaces
1. Fill the spray bottle: Unscrew the spray head from the spray bottle and fi ll the bottle
with cleaning agent and water in accordance with the manufacturer's specifi cations.
d
c
2. Press the On/Off switch (2) down to switch on the device.
3. Guide the nozzle over the surface to be cleaned. Check
during use whether the maximum fi ll level (marking) on
the collecting container has been reached. If this is the
case, it needs to be emptied.
4. Press the On/Off switch down again to switch off the de-
vice.
5. Empty the collecting container after each use and clean
its insert and the fi lter on a regular basis (see the "Clean-
ing the Device and Accessories" chapter). Also charge up
the battery (see the "Charging Up the Battery" chapter).
2. Place the wiping attachment (a) onto the spray head.
Press the fi xing ring (b) from the bottom up onto the wip-
ing attachment.
3. Stretch the wiping cloth (d) onto the wiping attachment
a
and secure it in place with the Velcro fastener.
b
4. Close the bottle again.
5. Spray the cleaning product evenly onto the surface which
is to be cleaned. To do this, press the spray lever (c) of
the bottle.
6. Detach the dirt using the wiping cloth. Note: If necessary,
rinse out the wiping cloth under running water!
7. Insert the nozzle with scraper lip (6) into the suction open-
ing of the device.
8. Switch on the device and suck up the cleaning liquid from
the surface by dragging the device from top to bottom.
9. The further procedure is the same as that for using the
other suction nozzles (see above).
23 EN