Abus TERXON M Instructions D'installation page 171

3. Via the keypad, select from the following items and
press:
Mode=Basic
0
See the appendix for a description
Mode=Summary
1
See the appendix for a description
Mode=Intermd
2
See the appendix for a description
Mode=Full
3
See the appendix for a description
4. Confirm your input. On the control unit, enter:
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
132 Transmit tampering as burglary
To change the settings:
1. On the control unit, enter:
2. The LCD display shows: 132:TA = BA OFF
3. Via the keypad, select from the following items and
press:
TA = BA OFF
The alarm centre transmits all SIA reports
0
as specified in command 131.
TA = BA ON
During an external alarm, the alarm
centre transmits tampering as a burglary
1
message and contact ID 130 instead of
Contact ID 137.
4. Confirm your input. On the control unit, enter:
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
133 SIA Rst
To change the settings:
1. On the control unit, enter:
2. The LCD display shows: 133:SIA Rst OFF
.
132
.
133
75
3. Via the keypad, select from the following items and
press:
SIA Rst OFF
The alarm centre does not transmit any
0
SIA reset reports (fire, panic, technical,
tamper resets)
SIA Rst ON
1
The alarm centre transmits SIA resets.
4. Confirm your input. On the control unit, enter:
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
143 Contact ID report Rst
To change the settings:
1. On the control unit, enter:
2. The LCD display shows: 143:Mode=Bas+Res
3. Via the keypad, select from the following items and
press:
Mode=Basic
All reports with numbers as in the „CID
0
Code" column apart from those marked
with a # (see appendix, SIA Report Mode)
Mode=Bas+Res
All reports with numbers as in the „CID
1
Code" column (see appendix, SIA Report
Mode)
4. Confirm your input. On the control unit, enter:
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
.
143
.
UK