Abus TERXON M Instructions D'installation page 168

UK
4. Confirm your input. On the control unit, enter:
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
114 Call back mode
To change the settings:
1. On the control unit, enter:
2. The LCD display shows: 114:Callback OFF
3. Via the keypad, select from the following items and
press:
0
1
2
4. Confirm your input. On the control unit, enter:
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
The alarm centre interprets a call as a
message from a remote PC. 10 to 90
seconds later, the remote PC calls again
once and the alarm centre answers
immediately on the first call. (Set
command 112 to a larger number of calls
than other end devices on the line)
114
CallBack OFF
(the call to the remote PC must be
triggered manually – command 0 user
mode).
CallBack ON
The alarm centre answers after the set
number of calls. The alarm centre hangs
up and checks the ID and software version
of the remote PC. After a short delay time,
the alarm centre calls back the PC (see
command 118+119).
CallBack ANY
When deactivated, the alarm centre
answers after a set number of calls
(command 112+113) and accepts the
programming commands immediately.
115 Telephone number 1
To change the settings:
1. On the control unit, enter:
2. The LCD display shows: 115:Tel No 1
3. Via the keypad, enter the telephone number.
Use key to enter a 4-second pause (shown by a
A
comma).
.
u
4. Confirm your input. On the control unit, enter:
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer mode.
116 Telephone number 2
See command 115.
117 Client no.
With SIA formats the control unit can report alarms using a
six-digit account code. Account code 1234 becomes
001234. To change the settings:
1. On the control unit, enter:
2. The LCD display shows: 117:Account No
3. Use the keyboard to enter the numbers of the client
no. („account no") for partition A.
Keys and move the cursor to the right and left.
C D
u
4. Confirm your input. On the control unit, enter:
5. Repeat step 3 for the additional partitions.
6. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
Some European countries use letters in the account number.
The alarm centre accepts the letters B, C, D, E and F. To
enters letters, use the keyboard the same way as when
assigning the zone names.
.
118 RemoteTel No 1
To change the settings:
1. On the control unit, enter:
72
115
.
117
.
118