Abus TERXON M Instructions D'installation page 150

044 Exit delay time A
To change the property of the exit mode for overall active A:
1. On the control unit, enter:
2. The LCD display shows: 044:Exit A=20
UK
3. Via the keypad, select from the following items and
press:
1
2
3
4
5
6
4. Confirm your input. On the control unit, enter:
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer mode.
044
Exit A=10
Exit delay time for overall active is 10
seconds.
Exit A=20
Exit delay time for overall active is 20
seconds.
Exit A=30
Exit delay time for overall active is 30
seconds.
Exit A=45
Exit delay time for overall active is 45
seconds.
Exit A=60
Exit delay time for overall active is 60
seconds.
Exit A=120
Exit delay time for overall active is 120
seconds.
045 Entry/exit delay tone volume
To change the property of the entry/exit delay tone volume:
1. On the control unit, enter:
2. The LCD display shows: 045:EE VOL=5
3. Via the keypad, select from the following items and
press:
EE VOL=OFF
0
Entry/exit delay tone off
EE Vol=1 / 2 / 3 / 4 / 5 / 6 / 7 / 8 / 9
1-9
Entry/exit delay tone quiet (1) to loud (9)
4. Confirm your input. On the control unit, enter:
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
046 Tamper alarm
To change the property of the tamper alarm for a deactivated
alarm centre:
1. On the control unit, enter:
2. The LCD display shows: 046: Int+RKP
3. Via the keypad, select from the following items and
press:
Internal
.
Following a tamper alarm when the alarm
0
centre is deactivated, only the intern alarm
is triggered.
Keypad
Following a tamper alarm when the alarm
1
centre is deactivated, the control unit is
triggered.
Int+RKP
Following a tamper alarm when the alarm
2
centre is deactivated, the control unit and
the internal alarm are triggered.
1. Confirm your input. On the control unit, enter:
2. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
54
045
.
046
.