Abus TERXON M Instructions D'installation page 117

Single system or partitioned system
The alarm centre can be operated as a single system or as a
partitioned system. In the single system, all locations, and 3
sections of the locations, are simultaneously activated or
deactivated. All control units, zones and outputs work for the
entire system.
If the alarm centre is functioning as a partitioned system then
it provides 4 smaller, independent alarm centres. In a
partitioned system:
every partition can be activated/deactivated independently
in case of an alarm.
various control units can be assigned to one or more
partitions. the control units can only activate/deactivate
partitions that are assigned to them.
every partition can have a separate signal transmitter.
zones can be assigned to several partitions, e.g. an entry
door zone can be used by several companies inside a
building.
A selection can be made between single systems or
partitioned systems the first time the alarm centre is put into
operation. If you want to change this later then use command
89 (reset to factory settings).
For additional information, please read „Programming
Partitions".
21
UK