Publicité
Les langues disponibles
Les langues disponibles
Notes on wiring
UK
AC
connection
Programmable floating
relay output (NC/NO) /
24VDC@1A
Programmable transistor output (OC). Max. power
consumption of all transistor outputs 0.5A.
Connection
AC mains supply unit
Kick Start jumper
Battery contact
COM interface
NVM Reset jumper
Fuses
Siren sabotage input
Optional loudspeaker
Local download connection
Connection for the
telephone connection
1A AUX fuse for the
power supply
2A BAT fuse for the
battery charging
Kick
Battery
Start
connection
Tamper input for ext.
components (e.g.
12V power supply for components
(e.g. detector)
Meaning
Contact for 230V main supply unit
Connect the two contacts of this jumper to start the alarm centre without a 230V mains power supply.
Connecting plug from standby power supply
Contact for additional transistor outputs
Connect the two contacts of this jumper to reset the alarm centre.
Always use fuses of the same type. To avoid problems, make sure there is always a good contact
between the fuse holder and the fuse.
For sirens with their own power supply, connect this input direct to the tamper output of the siren.
Otherwise, connect the tamper contact of the siren to the loop between the TR input and 0V. If no siren
is used, connect the TR input direct to the 0V output.
Connect a 16 Ohm loudspeaker for internal alerts.
You can connect a local PC here. The alarm centre can be configured using the downloader program.
RJ11 connection/screw connections for the telephone line
COM
interface
NVM Reset
Local
Download-
connection
tamper cover contact
EEPROM
anschluss
Alarm zones 1 – 8 for NC aöarm contact (e.g. IR
detector). No NO contacts can be connected. Make sure
alarm zones are terminated with correct resistors. Two
different resistors, or no resistor, must be used depending
on the programming. If the zone is used then the wire
bridge should be removed.
14
Connection for
telephone connection
control unit
Publicité
