Abus TERXON M Instructions D'installation page 158

072 Behaviour of exit mode internal (C)
To change the property of the exit mode for internal active
(C):
1. On the control unit, enter:
UK
2. The LCD display shows: 072: C=Low Tone
3. Via the keypad, select from the following items and
press:
4.
0
1
2
3
In a partitioned system
0
1
2
3
4
072
C=Low Tone
The acoustic signal during the exit delay
time is emitted at half volume.
C=Instant
During internal activation, the alarm
centre is internally activated immediately –
i.e., without delay.
C=Silent
No acoustic signal is emitted during the
delay time. Following expiry of the delay
time, the alarm centre emits a brief signal.
C=A
The initial mode for internal active B is as
for the initial mode of overall active A
C=Timed
Activation of partition C after exit time
(command 75). A connected key switch at
the control unit shortens the exit time when
activated
C=Terminated
Activated via key switch connected to the
control unit. The exit time is unlimited.
C=Final Door
Activation of the partition by closing a last
door detector
C=Instant
Active without delay time
C=Silent
Use command 75 for the exit time. The
control unit emits a double beep when the
time has expired.
C=Lock Set
5
Key switch (see command)
4. Confirm your input. On the control unit, enter:
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
073 Alarm behaviour for internal (C)
To change the alarm property for internal active (C):
1. On the control unit, enter:
2. The LCD display shows: 073: C = Internal
3. Via the keypad, select from the following items and
press:
C=Keypad
0
Only the control units are activated.
C=Internal
On alarm, the control units and the
1
internal alarm are activated.
C=Local
On alarm, the control units, the internal
2
alarm and the external siren are activated.
C=Full
On alarm, the control units, the internal
3
signalling, the external sirens and the exits
are activated.
In a partitioned system
C=Keypad
0
Only the control units are activated.
C=Local
On alarm, the control units, the internal
1
alarm and external sirens are activated.
C=Full
Control unit + internal + external +
2
telephone dialler
4. Confirm your input. On the control unit, enter:
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
62
.
073
.