Abus TERXON M Instructions D'installation page 125

After you press the Enter key, the display shows:
Hold the chip key in front of the control unit. You hear a
double tone. The chip key has been successfully
programmed. If required, you can also define a PIN for the
user. In this case, the user can choose between code and chip
key to activate/deactivate the alarm system.
To activate the TERXON M, enter the code or hold the chip
key in front of the system. You see the following display:
By pressing "A" or , you can now activate the complete
system. By pressing B, C or D, you can select individual sub-
areas. In this specimen installation, you could for example
activate sub-area B to arm the door contact and thus monitor
the exit doors.
The system is now fully installed and configured.
If you use SG1710 or SG1900 instead of SG1650, see the
following connection diagrams.
If you use the siren, transistor output OP1 (programming
menu: menu item 081) must be set to "Bell" (00).
Use the resistors provided to connect the SG1900 (1kOhm).
Do not forget to change the connector of the internal battery
from NC to Battery (–).
Se also the operating instructions of the signalling
equipment, which you should read carefully.
29
UK