Abus TERXON M Instructions D'installation page 127

Notes on programming
Program mode
All input in program mode is made via the keypad. The LCD
display gives you information about your input. For further
information about the programming items, see page 30.
Proceed as follows to change an item:
1. Via the keypad, enter the three-digit number of the
menu item (e.g.,
001
you want to view or change. To confirm your input,
press the Enter key
The selected menu item is shown on the LCD display.
2. To leave a setting unchanged, press the Enter key
.
3. Otherwise, enter the new value via the keypad. You
can see possible values in the programming table.
The new property is displayed.
4. To confirm and save the new value, press the Enter
key .
5. You can select a new item only if the LCD display
shows Installer Mode.
To exit the program menu:
1. The LCD display shows: Installer Mode.
99 a
2. Enter nd confirm your entry by pressing the
Enter key .
The LCD display shows:
3. Confirm your input by pressing the Enter key
cancel your input, press the X key
for Zone 1) whose property
.
Exit Eng. ?
. To
.
4. After you confirm your input with the Enter key
the alarm centre checks the current status of the
system. If everything is correct, the alarm centre
returns to normal operating state.
You have exited the program menu. The alarm centre
is now deactivated.
5. If there are any system faults, these are now
displayed. Possible faults are:
- Tamper contact of the alarm centre or
control unit open
- No mains or battery power available
- A zone is open that triggers immediate
alarm even when the alarm centre is
deactivated (24 hour, fire, tamper).
If there is a system fault, the program mode is not
exited. First clear all displayed system faults and
repeat the steps listed above.
Remarks
Factory settings
Program code: 7890
User code 1:
User codes 2–16:
Threat code:
31
1234
X002....X016 (not valid)
x017 (not valid)
,
UK