Abus TERXON M Instructions D'installation page 120

Specimen Installation
This specimen installation is intended to explain the use of
TERXON M.
UK
Here we use a system with two users. One user (de)activates
the alarm system using code input, the other with a chip key.
Furthermore, two sensors, a motion sensor (XEVOX ECO) and
door/window contacts (FU7350W) are connected to the
system. The complete system is armed using the key-switch
(SE1000).
The SG1650 signalling device (siren+flashlight) is used for
visual and acoustic signalling of an intrusion or panic alarm.
We also wish to explain in detail the programming of the
sensor types and of the transistor outputs for the external
alarm signalling equipment. Do not connect the equipment
yet to the mains power supply or the battery!
We start with the wiring of the alarm lines of the motion
sensor and door contacts. This is followed by an explanation
of the wiring of the tamper line.
Please use the 8-core alarm cable AZ6360 or AZ6361 for
connecting up. The following diagram shows how the sensors
are connected to the alarm centre:
Note that you need two extra lines for connected the tamper
line.
In the next step, we connect the control unit to the system.
Note that the jumper is not connected if only one control unit
is used (see page 13). Connect the control unit to the alarm
centre as shown.
Now connect the key switch (SE1000) to the system. Then
connect the cable supplied in the scope of delivery to the
connecting strip for the additional switching outputs. These
outputs are required for controlling the LEDs.
24