Publicité
Les langues disponibles
Les langues disponibles
Notes on wiring
Outdoor siren and flashlight
To deter burglars and alert the neighbourhood, we
recommend connecting a siren and a flashlight to the alarm
centre.
Note that these alarm devices should be mounted as high as
possible (e.g. at roof height) and the cables should not be
visible. Outdoor acoustic alarms can be a disturbance to the
neighbourhood. Observe country-specific regulations. We
recommend a maximum alarm duration of three minutes. A
visual alarm (flashlight) remains active until it is acknowledged
manually.
In addition to a siren and flashlight, we recommend
connecting the tamper contact of the combination signalling
device to the tamper input of the alarm centre. If the siren
housing is opened or the connection broken, the interrupted
tamper contact triggers a tamper alarm.
Connection example:
max. 500mA flash
max. 500mA sirene
Connecting a signalling device with its own power
supply
The functioning principle of this alarm signalling combination
is based on a permanent power supply of the siren and a
rechargeable battery integrated in the siren housing.
At a transistor output of the alarm centre, either a bias for the
siren is applied that is removed in the event of an alarm (or is
cut in the event of tampering), or the alarm centre issues a
trigger signal on alarm via the transistor output that activates
the siren and the flashlight.
The alarm duration of the siren is set on the signalling
equipment direct. Here too, the flashlight remains active until
it is acknowledged manually. For correct installation, please
read the installation instructions of the signalling device with
own power supply.
Connection example:
17
UK
Publicité
