Abus TERXON M Instructions D'installation page 146

3. Via the keypad, select from the following items and
press:
UK 0
1
4. Confirm your input. On the control unit, enter:
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
032 Control units and partitions
If you have created a partitioned system then using this
function, you can assign entry/exit zones, alarm zones and
status displays of partitions to the control units. To change this
feature, proceed as follows:
1. On the control unit, enter:
2. The LCD display shows: 032: Keypd 1 abcd
3. Via the keypad, select from the following items and
press:
A
B
C
D
6. Confirm your input. On the control unit, enter:
7. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
Repeat these steps for the remaining control units.
(1. Basic setting: all control units belong to all partitions. 2.
Key switches connected to control units can not be individually
assigned to partitions. 3. Panic alarms apply to all partitions.
EngTmpRstOFF
No program code necessary (OFF).
If a tamper alarm is triggered, you only
have to enter the user code to
acknowledge the tamper message.
EngTmpRstON
Program code required (ON)
If a tamper alarm is triggered, you have to
enter the user code to deactivate the
alarm and then the program code to
delete the tamper alarm.
032
Assignment of control unit 1 to partition A
Assignment of control unit 1 to partition B
Assignment of control unit 1 to partition C
Assignment of control unit 1 to partition D
033 System Reset
To change the property of the system reset:
1. On the control unit, enter:
2. The LCD display shows: 033: EngReset OFF
3. Via the keypad, select from the following items and
press:
EngReset OFF
If a system error is displayed, you only
0
have to enter the user code to
acknowledge the message.
EngReset OFF
If a system error is displayed, you have to
1
.
enter the program code to acknowledge
the message.
Note:
Some events always require you to enter the program
code. These are:
Failure/fault of a control unit
Failure of 12V power supply
Low battery in the alarm centre
4. Confirm your input. On the control unit, enter:
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
034 Panic Reset
Proceed as follows to change the property of the panic reset:
1. On the control unit, enter:
2. The LCD display shows: 034:PA Cust Rst
. 3. Via the keypad, select from the following items and
press:
PA Cust Rst
To reset a panic alarm, you only have to
0
enter a valid user code.
PA Eng Rst
To reset a panic alarm, you have to enter
1
the user code to deactivate the alarm and
50
033
.
034