Télécharger Imprimer la page

Ascend Alafia Mode D'emploi page 38

Publicité

Les langues disponibles

Les langues disponibles

C.7.2 Quick Release
The seat assembly should be adjusted with the seat centered on
the rails and level. It is recommended to add some grease to all
threads and binders on a bicycle, especially on the outside of the
seat post. Otherwise it may corrode over time and not be able to
be adjusted again.
❶ Unlock the quick-release lever and insert the seat post into the
seat tube. Figure 3.16
❷ Adjust the seat height up or down until the rider feels they
have control of the bicycle and are comfortable.
Important! Be sure the minimum insertion marks do not go
past the top of the seat clamp and are not visible. Figure 3.17
❸ Close the quick-release lever and lock the seat in place.
If there is not enough pressure to hold the seat in place open
the quick-release lever. With one hand on the quick-release
lever and one hand on the adjustment nut, start to hand
tighten the adjustment nut until you start to feel some
resistance against the post clamp. Do not attempt to tighten
by turning the quick-release lever. The quick-release lever is
for closing, the adjustment nut is for adjusting the pressure.
❹ Try to close the quick-release lever. If it closes easily, open it
up and tighten the adjustment nut further. If it is too difficult
to close, open the quick-release lever up and loosen the
adjustment nut a little and try again.
Important! You should feel resistance when you close the
quick-release lever that should leave a temporary impression
on your fingers. Open and close the handle to ensure the seat
is securely locked in place.
2
Seat post
Minimum insertion
marks on the seat post
Adjustment nut
Quick-release lever
ASSEMBLY C
Minimum
3
insertion
marks
Figure 3.17
Quick-release
seat clamp
1
Seat tube
Figure 3.16
33

Publicité

loading

Produits Connexes pour Ascend Alafia