Ascend Alafia Mode D'emploi page 30

C.4 ATTACH THE HANDLEBAR
WARNING!
• Improper attachment of the handlebar may result in damage
to the stem post, steerer tube and result in loss of control,
serious injury or death. Ensure the minimum insertion marks
on the stem post are not visible above the top of the headset.
• Failure to properly tighten handlebar components may result
in loss of control, serious injury or death. Always check the
handlebar cannot move and is secured to the frame before
riding the bicycle.
There are two types of stems that attach the handlebar to the
steerer tube. It is either a quill or clamp (threadless) stem.
C.4.1 Attaching a Quill Stem
❶ Turn the front fork to face forward. Figure 3.3
Position the handlebar assembly over the steerer tube.
Look at all the cables to be sure they run in a smooth arc
from the shifter or brake lever to the front brake or cable
stop on the frame. Important! If they are twisted or kinked,
the shifting and braking will not work.
❷ Insert the stem post into the steerer tube and adjust the
handlebar height until the rider feels they have control of the
bicycle and are comfortable. See Figure 1.2 for guidelines.
Important! Be sure the minimum insertion marks do not go
above the top of the headset and are not visible.
❸ Using a 6 mm Allen wrench tighten the stem binder bolt at the
top of the stem post. Check the handlebar binder bolt(s) to be
sure they are properly tightened and the handlebar is clamped
in place. Note: See Section A.3.3 if adjustments are needed.
3
Stem binder bolt
Stem post
2
Headset
Steerer tube
ASSEMBLY C
Handlebar
binder bolt(s)
Minimum
insertion
marks
1
Front fork
facing forward
Figure 3.3
25