Publicité
Les langues disponibles
Les langues disponibles
6. Work only during daylight hours with
good lighting and visibility (minimum visi-
bility required equal to the work area de-
fined in the "WORK AREA" paragraph).
7. Do not work during thunderstorms
and/or on wet or slippery ground.
8. Do not work on slopes of more than
10° unless using specific equipment
for work on slopes (not available on all
machines or versions). Use the utmost
caution when reversing the direction of
travel and when pulling the machine to-
wards you.
9. Always make sure that there are sup-
port points on slopes. Keep feet at a suit-
able distance from the tools and do not
put hands or feet near moving parts.
10. Always drive the machine with both
hands on the handlebar.
11. Do not work near ditches or embank-
ments. If a wheel crosses the roadside,
the car may suddenly overturn.
12. Do not reverse the machine with
your back to a wall or similar objects to
avoid being trapped.
13. Always work cross-wise on slopes,
never uphill or downhill.
14. It is essential to have the machine
checked professionally: for example if it
comes to a sudden stop as a result of
hitting an obstacle (gear damage, bent
blades).
Indications for the interchangeable
equipment:
1. Before installing, inspecting, repair-
ing, removing or replacing the inter-
changeable equipment or some parts of
it, stop the engine, letting the machine
cool down (15-20 minutes), and make
sure that there are no moving parts, dis-
connect the spark plug cap.
2. When handling the equipment for the
assembly, replacement or maintenance,
wear sturdy protective gloves. In gen-
eral, avoid contact with the equipment
tools and do not put your hands and feet
near the moving tools to avoid amputa-
tions and injuries.
3. Do not use the machine associated
with this equipment if the latter is not
correctly installed or if it does not oper-
ate properly.
4. Disengage the equipment by releasing
the lever when work is not performed or
if dangerous conditions such as the ap-
proach of strangers to the danger area,
any malfunctions, reduced visibility or
sudden impact against an obstacle are
felt.
5. Disengage the equipment if you cross
gravel drives or roads.
6. Disengage the equipment and turn off
the machine if you notice abnormal vi-
brations.
Instructions for adjustment and mainte-
nance:
DANGER!
All ADJUSTMENT and MAINTENANCE
operations must be carried out with the
motor switched off. Remove the spark
plug cap or ignition key (if present) to
avoid unexpected start-up.
Keep all nuts, bolts and screws tightened
to ensure safe machine operation.
Only use original Eurosystems spare
parts. The owner loses all warranty rights
when using non-original spare parts.
Do not make any structural changes or
adaptations. Such changes will invalidate
the warranty and the manufacturer's lia-
bility.
We reserve the right to make design im-
provements to the machine and/or the in-
terchangeable equipment without making
changes to these instructions.
Instructions for lifting:
DANGER!
Use lifting systems that are undamaged
and suitable for the masses to be lifted
(see the HANDLING AND TRANSPORT
paragraph).
DANGER!
Do not stand under suspended loads.
2.1 DESCRIPTION AND FIELD OF USE
The motor-cultivator MLT 03 is designed
and constructed exclusively for hobby use
on private land and can only be matched
to the accessories provided by the
manufacturer.
The motor-cultivator must only be used with
original equipment and spares.
ACCESSORIES (NOT INCLUDED):
- cutting bar 107 cm, code ABR102
- hay rake 100 cm, code ARA100
- rotating scythe 64 cm (4 floating blades,
cutting height fixed at 3.6 cm), code AFA64B
- grassland mower 63 cm (6 pivoting blades,
cutting height at 5 or 8 cm), code AFL63
- snow blade 85 cm, code ALN85C
- snow thrower 56 cm, code ATB56
- ABS brush 88 cm, ASP88A
- springs rotor de-thatcher 60 cm, code
ARI60
- rotavator 55 cm-Ø32, code AFR55
- vacuum/blower code ASR01
- transport tank code AVS02
- flat tank kit code APC03
- garden tank kit 140 l, code AVS140
- ridging plough code RIN29
- ECO sprayer code AMP02
OPTIONAL (NOT INCLUDED):
- rake kit (with side curtain for rake creation
51 cm)
- snow chains for wheels
- iron enlargement for pneumatics
- ballast (oscillating motor system which
allows the motor to be in a vertical position
when working on a slope)
2.2 IMPROPER USE
DANGER!
All the dangers described in this par-
agraph can generate serious injury or
death of the operator.
1. Use the machine only for the use in-
tended by the type of equipment mounted.
2. Do not use the machine to transport ob-
jects, people or animals.
3. Do not use the machine to tow and/or
push carts or other devices.
4. Do not mount equipment not authorized
by the manufacturer.
5. Do not modify machine parts.
6. Do not exclude or tamper with protec-
tion systems.
2.3 WORK AREA
3 . 1
3 . 1
The user is responsible for the safety of
persons, property and animals within the
machine danger zone.
This zone is defined as the internal area
of a circumference of a minimum radius
of 20 m with the tool mounted on the ma-
chine in the centre.
DANGER!
The danger area extends for 20 meters
around the machine and must be closed
with suitable warning signs.
DANGER!
The minimum radius of 20m can be in-
creased depending on the type of inter-
changeable equipment mounted on the
machine. See each specific manual for
more information.
Do not stand in the danger zone for any
reason while the machine is in operation.
Publicité
