Capture CPT-DVR4132XP Manuel D'utilisation page 169

User's Manual
Appendix 3 — Network Setup (LAN)
LAN Setup for Windows 98 System
1.
In the Windows mode, click Start on the Task Bar, move to Control Panel, and then to Network.
2.
Under the Configuration tab in the Network dialog box, move to Primary Network Logon and select
Windows Logon from the drop-down list. Click TCP/IP in the list of network components, and then click
the Properties button below.
NOTE: If TCP/IP is not listed, click the Add... button. In Select Network Component Type dialog box, select
Protocol from the list of network component types and click the Add... button. In the Select Network
Protocol dialog box, select Microsoft for the Manufacturer and TCP/IP for the Network Protocols. You can
save your changes by clicking the OK button. Selecting Cancel exits the dialog box without saving the
changes.
3.
Under the IP Address tab, click the Specify an IP address radio button. And enter the IP Address and
Subnet Mask acquired from your network administrator.
62