Capture CPT-DVR4132XP Manuel D'utilisation page 117

User's Manual
16.
Move to Remote control, and click the Set up Remote control... button when the DVR is controlled
remotely using the serial communication signals or network connections.
17.
Move to Serial (RS232 / RS485), and check the box and click the Set up Serial when the DVR is controlled
remotely using the serial communication signals. Select the DVR's COM port to use from the drop-down
list. Click the Set up port... button, and set the Baud rate from 300 to 256,000. Select Parity from None,
Even or Odd parity. Select Data bit from 7 bit or 8 bit format. Select Stop bit from 1 bit or 2 bits from the
drop-down list. Move to Device ID, and set the device ID number from 0 to 127 using the slide bar. See
Appendix 6 – Protocol for Remote Controlling DVR for details.
18.
Move to Network, and check the box and click the Set up Network when the DVR is controlled remotely
using the network connections. Enter the Network Port number.
19.
Move to HDD usage, and select either Once or Recycle.
recording when the hard disk drive is full. When Recycle is selected, the DVR continues recording when
the hard disk drive is full by overwriting the oldest video.
20.
Click the Set up Time Sync... button, and set up the time synchronization if required. See Appendix 7 –
Time Synchronization for details.
21.
Click the Change Signal... button, and select the video input signal to each camera number (Camera 1
to Camera 32) from a drop-down list (Input Signal 1 to Input Signal 16 for the camera numbers 1 to 16,
and Input Signal 17 to Input Signal 32 for the camera numbers 17 to 32).
22.
Click the Note... button, and set up the note function. The user can add or delete notes. If you want to
read the note, select the line and click the View button. Click the Load button to load the saved note,
the Save button to save the current note, and the Text Save button to save the current note to the text
file.
10
When Once is selected, the DVR stops