Publicité
Les langues disponibles
Les langues disponibles
User's Manual
Image Adjustment
Clicking the adjustment icon
below. Adjust the brightness, contrast, hue and saturation by clicking the designated buttons. Click the
Default button to reset them to the default settings. These adjustments should not be used to correct
improperly set cameras or monitors.
6
General tab
• Speed: Set the pan/tilt speed (from 1 to 16). The higher the
number,
the faster it moves.
• Move to origin: Click the button if you want to move the camera
to the
origin position.
• Auto Panning: Enables or disables auto panning.
• Camera: Turns on or turns off the camera.
• Menu: Enables or disables the menu function.
• Pump / Wiper / Light / Aux: Enables or disables pump, wiper, light
and other available functions.
Preset Sequence tab
• Sequence ID: Select the sequence ID (from 1 to 4).
• Preset ID: Select the preset ID (from 1 to 16).
• Dwell Time: Set the sequence dwell time (from 3 to 15 seconds)
for
each preset ID.
• Apply: Adjusts the current settings.
• Start: Starts the camera sequence. If you click the Start button,
the
camera will tour to the preset position during the preset dwell time
by
turns.
• Stop: Stops the camera sequence.
Sensor Association
• Sensor: Select sensor to associate it with the camera.
• Preset ID: Select the preset ID (from 1 to 16).
• Light / Pump / Wiper / Aux: Check the box if you want to use the
light, pump, wiper and/or other available functions when
the associated
sensor is activated.
• Apply: Applies the changes.
• On: Enables the sensor association. If you enable the sensor
association, the camera will move to the preset position,
and pump,
wiper light and/or other available functions will be initiated
when the
associated sensor is activated.
• Off: Disables the sensor association.
button causes the image adjustment buttons to display as shown
Publicité
