Publicité
Les langues disponibles
Les langues disponibles
System Status
•
Clock Mode: Click the left mouse button on the clock area, and set date display (MM-DD-YYYY/...)
and time display (12 Hours/24 Hours) formats. Click the right mouse button on the clock area, and set
date, time, and time zone.
CAUTION: If you change the time, images dated later than the new date/time are deleted. Back up the
images if you want to save them.
•
Mode Status: There are two operating modes; view only mode and recording mode. The SmartBase
records images only in the recording mode.
•
HDD Indicator: Shows the remaining hard disk space and the type of hard disk usage. Click the Setup
button and move to the System tab in the setup dialog box. Select the between Once and Recycle
for HDD usage.
NOTE: Once (displayed as Disk available: **%) records until the hard disk is full and then stops recording.
Recycle (displayed as Repeat Recording) records over the oldest images when the hard disk is full.
Camera Buttons
Click the individual camera buttons to display the selected camera. Click the
display the previous or next camera button panel.
Screen Buttons
•
To select the screen mode, click one of the screen buttons; single-screen, quad, 3+4, 3x3, 2+8, 4x4, 5x5,
1+32.
•
To view a specific image in the single-screen mode, move the cursor to that image and double click
the left mouse button. Click the left mouse button in the window to return to the previous screen
mode.
PTZ
Clicking the PTZ icon
SmartBase mode changes the PTZ setup of the remote DVR. Only the administrator can change PTZ setup
from a remote site.
Image Adjustment
Clicking the adjustment icon
brightness, contrast, hue and saturation of live or record image by clicking the designated buttons. Click the
Default button to reset them to the default settings. Only the administrator can adjust the image.
NOTE: These adjustments should not be used to correct improperly set cameras or monitors.
NOTE: It is important that images are properly adjusted. These adjustments cannot make up for improperly
adjusted images when the images are recorded.
Alarm
Clicking the alarm icon
alarm status and control the alarm output remotely. Only the administrator can control the alarm output
from a remote site.
button causes the PTZ control buttons to display. Controlling PTZ from the
button causes the image adjustment buttons to display. Adjust the
button causes the alarm control buttons to display. The user can check the
16-Channel Digital Video Recorder
or
button to
53
Publicité
