Capture CPT-DVR4132XP Manuel D'utilisation page 122

Setting Up Sensors
1.
Click the Sensor icon.
NOTE: Selecting 1-16 tab displays sensor channels to 16 and selecting 17-32 tab displays 17 to 32.
2.
Move to Enable, and check the box to enable the selected sensor.
3.
Move to Normally closed, and set the sensor type to Normally closed (NC) or Normally open (NO). If this
box is checked, it is in the normally closed mode. If it is not checked, it is in the normally open mode.
4.
Click the text field beside Description, and enter a sensor title such as "Front Door". You can use either the
actual keyboard or the virtual keyboard.
5.
Click the text field beside Sensor type, and enter a sensor type such as "magnet". You can use either the
actual keyboard or the virtual keyboard.
6.
Move to High priority, and check the box to give high priority to the target sensor so the DVR will follow
the advanced camera setup when the target sensor is activated. See the Setting Up Cameras for
configuring advanced camera setup.
7.
Move to Record Audio, and check the box to record audio when a selected sensor is activated.
Recording audio will be activated when at least one camera is associated with the sensor and the DVR is
recording video. When checking the Record Audio box, click the Set up Audio... button. Select an
audio input type from Microphone or Line-in, and set its balance and volume in the Recording Control
dialog box.
NOTE: The sound card provides two types of audio input, Microphone and Line-in. Microphone is for an
unamplified source while Line-in is for an amplified source. You must manually select the type of input.
NOTE: The voltages generated by microphones are very much smaller than those used in line level devices.
If you were to plug a Microphone into the soundcard Line in, you would never record anything.
16-Channel Digital Video Recorder
15