Publicité
Les langues disponibles
Les langues disponibles
User's Manual
Logging In/Out the System
Click the Logout button after logging out, the following User Login dialog box appears. Enter the User ID and
Password and then click the OK button if you want to log in the system. If the login fails more than three
times, the buzzer will be activated for three minutes. The successful login can stop the buzzer trigger during
the buzzer activation. The log for failed login as well as successful login will be displayed on the system status
window.
NOTE: When No local login is selected during SmartGuard – Authority setup, the DVR does not ask login
procedure.
NOTE: When you forgot the password, ask your dealer or distributor.
Click the Login button after logging in, the following Quit dialog box appears. Select logout and then click
the Yes button if you want to log out the system.
Monitor
Display Format: Various display formats (single-screen, full-screen, quad, 3+4, 3x3, 2+8, 4x4,
5x5 and 1+32) are provided for convenient user interface. Each format can be selected
by clicking the screen buttons shown below. The camera groups for multi-screen formats
are composed of cameras 1 to 32 in order. The user can select which camera group is
displayed by clicking any camera button in a group from camera buttons shown below.
OSD: Information including camera title, recording mode, and recording status can be
displayed on the image. Go to Setting Up the System in the SmartGuard Setup section,
and place a check in the Show OSD box to display the OSD information.
System Status
Clock Mode: Click the left mouse button on the clock area to set date display
(MM-DD-YYYY/...) and time display (12 Hours/24 Hours) formats. Click the right mouse
button on the clock area to set date, time and time zone.
CAUTION: If you change the time, images dated later than the new date/time are deleted. Back up the
images if you want to save them.
Mode Status: There are two operating modes – View only mode and Recording mode.
The SmartGuard records images only in the Recording mode.
HDD Indicator: Shows the remaining hard disk space and the type of hard disk usage.
Go to Setting Up the System in the Setup section, and select between Once and
Recycle for HDD usage.
4
Publicité
