Capture CPT-DVR4132XP Manuel D'utilisation page 127

User's Manual
Setting Up the Video Loss
1.
Click the Camera icon.
2.
Move to Detect Obscuration, and check the box to use the obscuration detection. And then set the
obscuration level from 0% to 50% by holding down and dragging the pointer.
percentage, the more sensitive it is. If the obscuration detection is selected, the DVR will check the
brightness of the target camera, and consider the obscuration on the images as video loss.
3.
Move to Detect Flare, and check the box to use the flare detection. And then set the flare level from 0%
to 50% by holding down and dragging the pointer. If the flare detection is selected, the DVR will check
the brightness of the target camera, and consider the flare on the image as video loss.
4.
Move to High priority, and check the box to give high priority to the target camera. The DVR will follow
the advanced camera setup when the target camera detects video loss. See the Setting Up Cameras
for configuring advanced camera setup.
5.
Move to Camera association, and click the camera icon to associate it with the camera selected step 1.
If video loss is detected by one camera, other cameras can be associated with it so that video will also
be recorded from the associated cameras.
6.
Move to Alarm association, and click the alarm icon to associate it with a selected sensor. The alarm will
go off when an associated sensor is activated.
7.
Move to Show video loss dialog, and check the box if you want to show the following Video Signal Failure
dialog box on the screen when the video loss is detected. Click the Acknowledge or Acknowledge All
button to close the dialog box.
20
The higher the