Spengler CARDIOMATE PC Manuel Utilisateur page 82

3) In the «ready to install» prompt box of the installation program, click 【Install】 to start the
installation process.
4) The installation program will automatically install the driver of the acquisition box and the
driver of the Dongle.
5) After the installation of Dongle driver, the interface for installing USB acquisition box driver
will pop up, and click 【Install】to start the installation of acquisition box driver.
6) After installation, in the «InstallShield Wizard» of the installation program, click 【Finish】.
Note : The software installation will automatically install the Driver for the Dongle and USB
acquisition box. If the driver installation fails, please install the driver manually.
4.2 Main Interface Function Introduction
4.2.1 System Startup
1. Turn on the the computer and printer.
2. Insert the USB Dongle into the USB port of the computer installed with ECG acquisition and
analysis software for Windows PC.
3. Run the software as an administrator and enter the ECG acquisition and analysis software for
Windows PC initialization main interface (as shown below):
Method 1: right click the software icon and choose to run as administrator. Follow this
procedure every time you open the software.
Method 2: right click the software icon and select Property → Compatibility → Run as
administrator.
82
www.spengler.fr