EMAK Oleo-Mac OM 105J Manuel D'utilisation Et D'entretien page 52

6 MAINTENANCE AND ADJUSTMENT
Properly performed regular maintenance and inspection of the riding mower helps to increase its problem-free operating lifetime.
Worn or damaged parts must be replaced in time. When replacing parts, use only original spare parts, using non-original parts
may damage the mower, endanger the health of the driver or other persons and during the warranty period it voids the
warranty. To order spare parts, always contact the mower's manufacturer or an authorised service centre.
Incorrectly performed or completely neglected maintenance may lead not only to problems with the operation of the riding mower, but
may also cause injury to its operator.
All safety and protective elements that are removed during maintenance, must always be reinstalled to their correct location and
tested for functionality.
6.1 OVERVIEW OF CHECKS AND MAINTENANCE
INTERVAL
Engine and transmission
Travel drive belt
Brake
BEFORE EVERY
Tyres
USE
Cables
Bolt connections
Mowing deck
Safety switches and elements
AFTER FIRST 2
Engine and transmission
HOURS
Travel drive belt
AFTER FIRST 5
HOURS
Mowing deck
Mowing deck
AFTER EVERY USE
The entire mower
Grass catcher
Bolt connections
Bolt connections
Travel drive belt
Front axle and steering
AFTER 25 HOURS
Mowing deck
Lubrication
ASSEMBLY
Check oil level
Inspection and adjustment
Inspection of controls
Inspection of pressure
Inspection of mounting, inspection of quick coupler parts
Inspection, tightening if necessary
Inspection of tension of the cogged blade drive belt
Inspection of function
Check oil level
Inspection and adjustment
Inspection of tension of the cogged blade drive belt
Inspection of the correct tension of the mowing deck drive
V-belt 4
Cleaning and washing
Inspection of the correct tension of the mowing deck drive
V-belt
Cleaning
Cleaning of the textile sack
Inspection, tightening if necessary
Inspection, tightening if necessary
Inspection and adjustment
Inspection and adjustment of play
Inspection of play, alignment of shafts, inspection and
sharpening of blades
Lubrication of parts according to lubrication plan
52
ACTIVITY
4
3
6.2.1
6.3.16
6.3.12
6.2.1
6.2.1
6.2.1
6.2.1
6.3.9
6.2.1
6.2.1
6.3.12
4
6.3.9
6.3.8
6.2.2
6.3.8
6.2.2
6.2.2
6.2.1
6.2.1
6.3.12
6.3.11
6.3.6
6.3.7
6.4