EMAK Oleo-Mac OM 105J Manuel D'utilisation Et D'entretien page 37

INSTALLATION OF THE GRASS CATCHER
► Screw the grass catcher hinges (1) on to the rear plate. For this purpose use the installation markings on the plate
indicating the correct position of the hitches.
3.3.2c
► Only screw on the lower hitch (2) if you will be using a trailer (optional equipment).
► Screw the front tube under the lid of the top frame.
3.3.2d
► Attach the contact spring for the full grass catcher sensor on the left side of the top frame plate.
3.3.2e
► Screw in the slanting tube into the grass catcher. For a grass catcher with a capacity of 320 l use the holes closer to
the front tube; for the grass catcher with a capacity of 380 l use the holes farther away from the front tube.
3.3.2f
► Tilt the grass catcher by 90
the front tube and the second side to the slanting tube. For the 320 l grass catcher use two braces, for the 380 l
3.3.2g
grass catcher use three braces.
► Pull the rubber edges of the sack over the front tube.
3.3.2h
► Insert the protective shield (2) between the grass catcher lid and the brace (1). Put the top handle (3) on from above
and screw it on to the lid using two screws inserted from the underside into the grooves of the brace.
3.3.2i
► Insert the dump lever handle into the hole in the grass catcher lid.
► Into the holes in the bottom end of the lever, screw in a self-tapping bolt from the outside.
3.3.2j
ADJUSTMENT OF THE GRASS CATCHER POSITION AFTER INSTALLATION
► Hang the grass catcher on the hitches (1) on the rear plate of the mower.
► Check that the grass catcher and the mudguards match up. The arrow tips stamped on the lid of the grass catcher
and the mower's fairing must point to each other while the distance between the grass catcher and the grass
3.3.2k
catcher plate must be no greater than 3 mm.
► If the grass catcher does not align, it means that the hitches (1) are not in the correct position.
► Remove the grass catcher and adjust the position of the hitches relative to the direction that it did not align with the
mower:
- loosen screws (A) to move the hitches up and down
- loosen screws (B) to move the hitches forwards and backwards
3.3.2l
► After adjusting the position, tighten the screws and again hang the grass catcher and check that it is in the correct
position.
► Also check the position of the contact spring of the full grass catcher sensor (10) – the spring must be touching the
switch (C), otherwise the mowing deck will not function.
o
and from the bottom side screw on the lower braces. Attach one side of the braces to
37