EMAK Oleo-Mac OM 105J Manuel D'utilisation Et D'entretien page 36

3.3.2 GRASS CATCHER
The grass catcher is supplied packed in a separate box. For transportation reasons some of its parts are demounted and they first
need to be assembled. The following chapters provide a rough indication of their assembly.
NECESSARY TOOLS
For the assembly of the grass catcher, prepare the following tools:
►
A knife for removing packaging materials
UNPACKING
Remove packaging materials. First take out the lid, frame and sack and then the wrapped individual parts. Unpack these parts and
arrange them clearly in a suitable place.
INCLUDED CONTENTS
(1) Lid with top frame
(2) Sack
(3) Grass catcher hitches
(4) Dump lever handle
(5) Front tube
(6) Slanting tube
(7) Lower braces
3.3.2a
(8) Lower hitch (for trailer)
(9) Lid handle
(10) Contact spring of full grass catcher sensor
(11) Fastening bolts, nuts and washers
(12) Protective shield
A part of the grass catcher package are also spare break pins for the cutting blades (4 pcs). Keep these pins for future
use.
GRASS CATCHER - DESCRIPTION OF THE MAIN PARTS (TERMINOLOGY)
Positions correspond to the numbers in illustration 3.3.2a.
(1) Lid
(2) Sack
(4) Dump lever handle
(5) Front tube
(6) Slanting tube
3.3.2b
(7) Lower braces (under the floor of the sack)
(9) Top Handle
(10) Contact spring of full grass catcher sensor
►
A set of socket wrenches with hex heads
and hex wrenches
36
►
Philips screwdrivers or a handheld electric
screwdriver