Saving, Displaying And Deleting Measured Values; Error Message/Troubleshooting - Beurer BC 30 Mode D'emploi

Blood pressure Systole
value category (in mmHg)
Setting 3:
severe red ≥ 180
hyper tension
Setting 2:
moderate orange 160 – 179
hypertension
Setting 1:
mild hyper- yellow 140 – 159
tension
High normal green 130 – 139
Normal green 120 – 129
Optimal green < 120
Source: WHO, 1999 (World Health Organization)
7. Saving, displaying and deleting
measured values
The results of every successful measurement are stored
together with the date and time. If there are more than
60 measurements, the oldest measurements are lost.
Diastole
Action
(in mmHg)
seek
≥ 110 medical
attention
seek
100 – 109 medical
attention
regular
90 – 99 monitoring
by doctor
regular
85 – 89 monitoring
by doctor
self-moni-
80 – 84
toring
self-moni-
< 80
toring
26
• Use the button and then the
desired user memory. Pressing the +/M button displays
the average value of the 3 most recent measurements
stored in the user memory. If you continue to press the
memory button +/M, the most recent individual measu-
red values are displayed in turn with the date and time.
• To delete individual measurements, you must first se-
lect them. Press and hold the memory button +/M until
appears in the display. Then confirm the deletion
with the user selection button
on the display).
• To delete measurements from a user memory, you
must first select them. Press the memory button +/M
and the average value of the last 3 saved measure-
ments is displayed. Then press and hold the memo-
ry button +/M again until
Confirm the deletion with the user selection button
( and appear on the display).

8. Error message/troubleshooting

In the event of errors, the error message _ appears
on the display.
Error messages may appear if:
• it was not possible to record the pulse:
• you move or speak during the measurement:
• the cuff is fastened too tightly or loosely:
button to select the
( and appear
appears in the display.
;
;
;