Beurer BC 30 Mode D'emploi page 19

Masquer les pouces Voir aussi pour BC 30:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 29
• In the case of restricted circulation on the arm as a re-
sult of chronic or acute vascular diseases (including
vascular constriction), the accuracy of the wrist meas-
urement is limited. In this case you should avoid using
an upper arm blood pressure monitor.
• Cardiovascular diseases may lead to incorrect meas-
urements or have a detrimental effect on measurement
accuracy. The same also applies to very low blood
pressure, diabetes, circulatory disorders and arrhyth-
mias as well as chills or shaking.
• The blood pressure monitor must not be used in con-
nection with a high-frequency surgical unit.
• Only use the unit on people who have the specified
wrist measurement for the device.
• Please note that when inflating, the functions of the
limb in question may be impaired.
• During the blood pressure measurement, blood circu-
lation must not be stopped for an unnecessarily long
time. If the device malfunctions, remove the cuff from
the arm.
• Do not allow sustained pressure in the cuff or frequent
measurements. The resulting restriction of the blood
flow may cause injury.
• Ensure that the cuff is not placed on an arm in which
the arteries or veins are undergoing medical treat-
ment, e.g. intravascular access or therapy, or an arte-
riovenous (AV) shunt.
• Do not use the cuff on people who have undergone
a mastectomy.
• Do not place the cuff over wounds as this may cause
further injury.
• Place the cuff on your wrist only. Do not place the cuff
on other parts of the body.
• The blood pressure monitor can only be operated with
batteries.
• To conserve the batteries, the monitor switches off au-
tomatically if no buttons are pressed for two minutes.
• The device is only intended for the purpose described
in these instructions for use. The manufacturer is not
liable for damage resulting from improper or careless
use.
Instructions for storage and maintenance
• The blood pressure monitor is made from precision
and electronic components. The accuracy of the
measurements and service life of the device depend
on its careful handling:
– Protect the device from impacts, humidity, dirt,
marked temperature fluctuations and direct sunlight.
19

Publicité

Table des Matières
loading

Table des Matières