Saving, Displaying And Deleting Measured Values; Error Message/Troubleshooting - Beurer BC 30 Mode D'emploi

Blood pressure Systole
value category (in mmHg)
Setting 3:
severe ≥ 180
hypertension
Setting 2:
moderate 160 – 179 100 – 109
hypertension
Setting 1:
140 – 159 90 – 99
mild hypertension
High normal 130 – 139 85 – 89
Normal 120 – 129 80 – 84
Optimal < 120
Source: WHO, 1999 (World Health Organization)
7. Saving, displaying and deleting
measured values
The results of every successful measurement are stored
together with the date and time. If there are more than
60 measurements, the oldest measurements are lost.
All manuals and user guides at all-guides.com
Diastole
Action
(in mmHg)
seek
≥ 110 medical
attention
seek
medical
attention
regular
monitoring
by doctor
regular
monitoring
by doctor
self-
monitoring
self-
< 80
monitoring
• Use the button and then the
the desired user memory. Pressing the +/M button
displays the average value of the 3 most recent mea-
surements stored in the user memory. If you continue
to press the memory button +/M, the most recent in-
dividual measured values are displayed in turn with
the date and time.
• To delete individual measurements, you must first se-
lect them. Press and hold the memory button +/M until
appears in the display. Then confirm the deletion
with the user selection button
on the display).
• To delete measurements from a user memory, you
must first select them. Press the memory button +/M
and the average value of the last 3 saved measure-
ments is displayed. Then press and hold the memo-
ry button +/M again until
Confirm the deletion with the user selection button
( and appear on the display).

8. Error message/troubleshooting

In the event of errors, the error message _ appears
on the display.
Error messages may appear if:
• it was not possible to record the pulse:
• you move or speak during the measurement:
• the cuff is fastened too tightly or loosely:
27
button to select
( and appear
appears in the display.
;
;
;