Measuring Blood Pressure - Beurer BC 30 Mode D'emploi

• The codes below are printed on batteries
containing harmful substances:
Pb = Battery contains lead,
Cd = Battery contains cadmium,
Hg = Battery contains mercury.
Setting the date and time
You should set the date and time without fail. Otherwise,
you will not be able to save your measured values cor-
rectly with a date and time and access them again later.
The time is displayed in the 24-hour format.
To set the date and time, proceed as follows:
1. After inserting the batteries:
• Following the display check, during which all seg-
ments appear, the year flashes on the display.
• Using the +/M button, you can increase the basic va-
lues to be set. Set the year and confirm the entry using
the button.
• Now set the month using the +/M button. Confirm
using the button.
• Set the day/hour/minute and confirm each using the
button.
• To switch off, press the START/STOP button
2. At any time:
• Press the button to display the date/time and cur-
rent user memory.
All manuals and user guides at all-guides.com
• Press and hold the
• Set as described above.

5. Measuring blood pressure

Ensure the device is at room temperature before meas-
uring. The measurement can be performed on the left
or right wrist.
Attach the cuff
• Expose your wrist. Ensure that the circulation of the
• Place the cuff on the inside of your wrist.
• Fasten the cuff with the hook and loop fastener so that
.
• The cuff must be fitted tightly around the wrist, but
24
conds to reach Date and time mode.
1 2
arm is not hindered by tight clothing or similar.
the upper edge of the monitor is positioned approx. 1
cm below the ball of your thumb.
must not constrict.
button again for about 3 se-
3