Measuring Blood Pressure; Selecting Memory - Beurer BC 30 Mode D'emploi

• Press and hold the
onds to reach Date and time mode.
• Set as described above.

5. Measuring blood pressure

Ensure the device is at room temperature before meas-
uring. The measurement can be performed on the left
or right wrist.
Attach the cuff
1 2
• Expose your wrist. Ensure that the circulation of the
arm is not hindered by tight clothing or similar.
Place the cuff on the inside of your wrist.
• Fasten the cuff with the hook and loop fastener so that
the upper edge of the monitor is positioned approx. 1
cm below the ball of your thumb.
• The cuff must be fitted tightly around the wrist, but
must not constrict.
Blood pressure may vary between the right and left wrist,
which may mean that the measured blood pressure val-
button again for about 3 sec-
3
ues are different. Always perform the measurement on
the same wrist.
If the values between the two wrists are significantly dif-
ferent, please consult your doctor to determine which
wrist should be used for the measurement.
Adopt the correct posture
• Before every measurement, relax for about five
minutes. Otherwise deviations can occur.
• You can perform the measure-
ment while sitting or lying. To car-
ry out a blood pressure measure-
ment, make sure you are sitting
comfortably with your arms and
back leaning on something. Do
not cross your legs. Place your
feet flat on the ground. Make sure to rest your arm
and move it. Always make sure that the cuff is at heart
level. Otherwise significant deviations can occur. Relax
your arm and the palm of your hand.
• To avoid falsifying the measurement, it is important to
remain still during the measurement and not to speak!

Selecting memory

Press the button to display the date/time and current
user memory. Select the desired user memory by press-
23