Preparing The Measurement; Battery Disposal - Beurer BC 30 Mode D'emploi

4. Preparing the measurement

Insert the batteries
• Remove the bat-
tery compartment
lid on the left side
of the device.
• Insert two 1.5 V
micro (alkaline type LR03) batteries.
Make sure that the batteries are inserted the correct
way round. Do not use rechargeable batteries.
• Close the battery compartment lid again carefully.
If the battery change symbol is flashing and
pears, no more measurements are possible and you must
replace all batteries.
After inserting the batteries, the year appears on the
display and you can then set the date and time.

Battery disposal

• The empty, completely flat batteries must be disposed
of through specially designated collection boxes, re-
cycling points or electronics retailers. You are legally
required to dispose of the batteries.
• The codes below are printed on batteries
containing harmful substances:
Pb = Battery contains lead,
Cd = Battery contains cadmium,
Hg = Battery contains mercury.
Setting the date and time
You should set the date and time without fail. Otherwise,
you will not be able to save your measured values cor-
rectly with a date and time and access them again later.
The time is displayed in the 24-hour format.
To set the date and time, proceed as follows:
ap-
1. After inserting the batteries:
• Following the display check, during which all segments
appear, the year flashes on the display.
• Using the +/M button, you can increase the basic val-
ues to be set. Set the year and confirm the entry using
the button.
• Now set the month using the +/M button. Confirm us-
ing the button.
• Set the day/hour/minute and confirm each using the
button.
• To switch off, press the START/STOP button
2. At any time:
• Press the
rent user memory.
22
button to display the date/time and cur-
.