Preparing The Measurement - Beurer BM 55 Mode D'emploi

Information on the display:
1. Date / time
2. Systolic pressure
3. Diastolic pressure
4. Pulse value
5. Pulse symbol
6. Release air (arrow)
7. Number of memory
space/memory display
average value ( ),
morning ( ),
evening ( )
8. Battery replacement
symbol
9. User memory
10. Risk indicator
11. Cardiac arrhythmia symbol
Computer interface
The blood pressure monitor also allows you to transfer your
measured values to the computer.
For this, you will need a USB cable (included in delivery) and
the "beurer HealthManager" computer software.
The software can be downloaded free of charge from the
download area under Service at www.beurer.com.
System requirements for the "beurer HealthManager"
computer software
• Windows 7 SP1 or higher
• USB 2.0 (Type A) or higher
11
10
9
8
7 6 5

4. Preparing the measurement

1
Inserting the batteries
• Remove the battery compart-
ment lid on the rear of the
device.
2
• Insert four 1.5 V AAA (alkaline
type LR03) batteries. Make
sure that the batteries are
3
inserted the correct way round.
Do not use rechargeable bat-
teries.
4
• Close the battery compartment
lid again carefully.
All display elements are briefly displayed,
display. Set the date and time as described below.
If the battery replacement symbol
played, you can no longer perform any measurements and
must replace all batteries. Once the batteries have been
removed from the device, the date and time must be set again.
Any saved measurements are retained.
Battery disposal
• The empty, completely flat batteries must be disposed of
through specially designated collection boxes, recycling
points or electronics retailers. You are legally required to
dispose of the batteries.
25
4 x 1,5V AAA (LR03)
flashes in the
is permanently dis-