Saving, Displaying And Deleting Measured Values - Beurer BM 93 Cardio Mode D'emploi

the symbol is shown on the display after the measurement has been taken, repeat the meas-
urement. Please ensure that you rest for 5 minutes beforehand and do not speak or move during
the measurement. If the symbol
and treatment based on the measurements can be dangerous. Always follow your GPs instructions.
Risk indicator
The measured values can be classified and evaluated in accordance with the following table.
However, these standard values serve only as a general guideline, as the individual blood pressure
varies in different people and different age groups etc.
It is important to consult your doctor regularly for advice. Your doctor will tell you your individual
values for normal blood pressure as well as the value above which your blood pressure is clas-
sified as dangerous.
The bar chart on the display shows which category the recorded blood pressure values fall into. If
the values of systole and diastole fall into two different categories (e.g. systole in the 'High normal'
category and diastole in the 'Normal' category), the graphical classification on the display always
shows the higher category; for the example given this would be 'High normal'.
Blood pressure value category Systole
Level 3: severe hypertension
Level 2: moderate hypertension
Level 1: mild hypertension
High normal
Normal
Optimal
Source: WHO, 1999 (World Health Organization)

7.6 Saving, displaying and deleting measured values

The device has two user memories. Each user memory can store up to 60 measured values. Once
all memory spaces in a user memory have been used, the oldest measured values are replaced by
the most recent.
appears frequently, please consult your doctor. Selfdiagnosis
Diastole
(in mmHg) (in mmHg)
≥ 180 ≥ 110
160 – 179 100 – 109
140 – 159 90 – 99
130 – 139 85 – 89
120 – 129 80 – 84
< 120 < 80
47
Action
seek medical attention
seek medical attention
regular monitoring by doctor
regular monitoring by doctor
self-monitoring
self-monitoring