Publicité
Fig. 7.1
Fig. 7.2
Fig. 8
Fig. 9
Fig. 10
62
the saw blade. It should move itself onto the work piece
during sawing.
Length latch assembly fig. 7.1-7.2
Push the length latch track between the clamping block
and the set pipe on the latch and tighten this with the
two wing screws.
Please note the two possibilities.
• For a higher stop: read this at the front, fig. 7.1.
• For a lower stop: read this on the scale at the back
fig.7.2
Cross cut gauge assembly, fig. 8
• Put the stop track with the two knurled head screws
in the niche of the swinging arm and clamp these
down tight.
• The cross cut gauge can be used on the left or the right
side of the saw blade in the groove.
Storing the pusher, fig. 9
Place the pusher after each use back into its storage
place.
Storing the length latch and the cross cut gauge fig. 10
If the cross cut gauge and the length latch are not being
used, these can be stored on the side of the holder.
Publicité
