Publicité
Fig. 1
6
13
8
9
1
12
14
10
4
Fig. 2
Fig. 3
58
7
5
2
3
11
a
b
1
Stand
2
Table plate
3
Table extension
4
Folding feet
5
Splitter with laser unit
6
Protective cover
7
Vacuum hose
8
Saw blade
9
Table insert
10 On/Off switch
11 Length latch
15
12 Tension lever for length latch
13 Cross-cut gauge
14 Height adjustment wheel
15 Castors
16
16 Safety feet
Assembly and Installation
All assembly and retrofitting work may only be performed
when the mains plug has been disconnected.
Your circular sawbench is not completely assembled for
packaging reasons.
• Open the cardboard box and remove packaging and
styrofoam material.
• Take the parts from the cardboard box.
• Take the saw from the cardboard box and put it to the
side on the ground; use cardboard as underlying to
protect the surface.
• Release the feet on both sides using the lever (fig.
2, a)
• Fold the feet outwards and secure them by means of
the locking levers (b) on both sides (Fig. 3)
Fig. 2
• Take the saw out of the carton and place it on its side
with the wheels on the ground.
• Release the feet on both sides with the lever (a).
Set up the frame horizontally, fig. 3
Unfold the feet outwards and secure them with the latch-
ing lever (b) on both sides
Equipment, Fig. 1
Publicité
