Important Codes For Quick Commissioning - Lenze 8200 vector Instructions De Montage

7 Commissioning

Important codes for quick commissioning

7.4 Important codes for quick commissioning
The following table describes the codes mentioned in the commissioning examples. A
description of all codes can be found in the system manual, chapter "Function library".
How to read the code table
Column Abbreviation
Code Cxxxx
1
2
*
v
s
(A)
uSEr
Designation
Lenze
à
Selection 1
IMPORTANT −
Code Possible settings
No. Name Lenze
C0002*
Parameter set
s
management
uSEr
Restoring the
delivery status
176
Meaning
Code Cxxxx
Subcode 1 of Cxxxx
Subcode 2 of Cxxxx
Parameter value of the code is the same for all parameter sets and can be
changed in parameter set 1
Keypad E82ZBC
Keypad XT EMZ9371BC
Keypad E82ZBC
Keypad XT EMZ9371BC
Code, subcode or selection only available for operation with application I/O
Code is contained in the Lenze setting in the USER menu
Name of the code
Lenze setting (value at delivery or after restoring the delivery status with C0002)
Further information can be obtained from the "IMPORTANT" column
{%} 99 Min. value
Brief, important explanations
Selection
0 0 Ready
Lenze setting ð PAR1
1
Lenze setting ð PAR2
2
Lenze setting ð PAR3
3
Lenze setting ð PAR4
4
Lenze setting ð FPAR1
31
Lenze setting ð PAR1 + FPAR1
61
Lenze setting ð PAR2 + FPAR1
62
Lenze setting ð PAR3 + FPAR1
63
Lenze setting ð PAR4 + FPAR1
64
l
l
The parameter value of the code can be defined
differently within each parameter set
l
The parameter value is accepted immediately
(ONLINE)
Changed parameter of the code or subcode will be
accepted after pressing v
Changed parameter of the code or subcode will be
accepted after pressing T V
Changed parameter of the code or subcode will be
accepted after pressing v if the controller is inhibited
Changed parameter of the code or subcode will be
accepted after pressing T V if the controller is
inhibited
{unit} max. value
IMPORTANT
PAR1 ... PAR4:
l
Parameter sets of the controller
l
PAR1 ... PAR4 also contain the
parameters for the function
modules standard I/O, application
I/O, AS interface, system bus (CAN)
FPAR1:
l
Module−specific parameter set of
the fieldbus function modules
INTERBUS, PROFIBUS−DP, LECOM−B,
DeviceNet/CANopen
l FPAR1 is saved in the function
module
Restore the delivery status in the
parameter set selected
Restore the delivery status in the
fieldbus function module
Restore the delivery status in the
selected parameter set of the
controller and in the fieldbus function
module
EDK82EV903 DE/EN/FR 5.1