DS Produkte 00052 Mode D'emploi page 41

• Use the steamer adapter without intermediate panel to cook a larger quantity of the
same food.
• Insert the intermediate panel in the steamer adapter to cook a larger quantity of the
same food and prevent it from being heaped (e.g. yeast dumplings) or to cook differ-
ent foods at the same time (e.g. vegetables and meat). Make sure that the food with a
longer cooking time is at the bottom and food with a shorter cooking time is at the top.
1. Connect the motor unit as described in the section "Basic use of the device" and
make sure that the cross-blade adapter is correctly fi tted in the mixing bowl.
2. Fill the mixing bowl with at least 0.5 litres of water for a cooking time of 30 minutes. In
case of a prolonged cooking time, the required amount of water increases by 250 ml
for every 15 additional minutes. However, do not exceed the MAX mark. To enhance
the fl avour of food, e.g. broth or a mixture of water and wine can also be used instead
of water.
3. Place the mixing bowl in the motor unit.
4. Place the steamer adapter on the mixing bowl. Follow the instructions in the chapter
"Using the accessories properly", section "Steamer unit". In the process, make sure
that the adapter is correctly seated.
5. Fill it with the desired food that is not packed down. Make sure that some of the vents
are not obstructed to allow the steam to rise. If necessary, insert the intermediate
panel in the steamer adapter.
6. Place the lid on the steamer adapter. Make sure that it is correctly fi tted to prevent too
much steam from being released and food from being improperly cooked.
7. Turn on the motor unit (by fl ipping the On/Off switch to position I).
8. Set the cooking time and temperature, which the liquid in the mixing bowl should be
heated to.
9. Push the
cross-blade adapter to the speed level 1 to 2.
10. If, before the set cooking time has elapsed, you would like to check whether the food
is done, push the
11. Gently tip the lid forward so that the steam can escape to the back. Make sure that
the condensation drips into the steamer adapter by holding it in the middle over it. You
can then carefully remove the lid.
12. To remove the steamer adapter, turn it slightly counterclockwise. Lift it, wait a few
seconds until the steam condenses and has dripped into the mixing bowl before you
place it on a heat-resistant base.
13. If you would like to continue steaming, fi t the steamer unit back on the mixing bowl
and push the
14. To turn off the device, set the On/Off switch to the 0 position and then pull the mains
plug out of the socket.
15. Take the steamer unit off of the mixing bowl as described with step 12. Then carefully
lift the mixing bowl out of the motor unit and pour the hot water out.
00052_de-en-fr-nl_A5_V3_1.indb 41 00052_de-en-fr-nl_A5_V3_1.indb 41
button and the device will start working. You can also switch on the
button to stop the device and the timer.
button. The timer will continue to run.
41 EN
26.04.2018 08:55:56 26.04.2018 08:55:56