Publicité
Les langues disponibles
Les langues disponibles
Keep the wires as short as possible!
Use 2,5 mm² silicon insulated wire to the motor and to the
battery.
Secure the wires against heat and moving parts.
Keep the motor and battery wires away from the antenna
and the receiver.
Avoid connectors between the controller and the motor.
Solder the wires.
Use an Y-Adapter cable with electronical mixing.
Plug the end of the cable in the output of the receiver.
Now connect both of the ends of the Y-Adapter cable with
the speed controller and the pitch servo.
You may have to extend the connection cable of the
tailrotor servo with an additional extension piece.
The receiver: You could possibly strip the body for even more weight
reduction. Check with your warranty!
We recommend, Ikarus Master Gyro Order No. 720610, Telegyro (Order
No. 720611), Profi Gyro (Order No. 720613), Micro Gyro (Order No
720615) and Mini Gyro (Order No. 720654).lightweight and compact,
developed especially for small helicopters.
Use vibration absorbing servo tape to fix the receiver and the gyro onto
the r/c-plates.
The speed controller Heli 4000 is a microcomputer based system that can
easily be adapted to any R/C-System. The motor starts only after certain
procedures on the transmitter. The Controler Heli 4000 fits perfectly well
into the main frame and allows short wiring to the battery and to the motor.
When working on the helicopter with a battery
connected accidents may happen due to
unexpected motor start. When working on the
helicopter please always remove the motor
pinion for maximum safety.
Insert the battery into the undercarriage and adjust the
center of gravity.
Hold the helicopter at the flybar. The helicopters nose
should drop down a little. Adjust by moving the battery to
the back or to the front. Mark the final position with tape.
Publicité
