Publicité
Les langues disponibles
Les langues disponibles
Make sure that all servos are in
neutral position.
Use the rubber servo grommets
to prevent damage from vibration.
Attention: Never turn the ser-
vos manually. The gear unit of
the servos is not constructed
for this kind of actions.
1x
67526
Tie rod M2x160 mm
2x
67523
Quick link
1x
67513
Tailrotor snake
6 mm
67523
abt. 167 mm
Carefully select the components of your r/c-equipment in view of quality and weight. Keep in mind:
Saving 1 g of weight gives you 1 s more flight time!
Using unsuitable components can cause serious damage!
If you have the choice, choose the more sophisticated equipment.
Connect the components as suggested by the manufacturer.
Use the rubber servo grommets to prevent damage from vibration.
Use the installation material provided with the servos.
Make sure that all servos are in neutral position.
In order to clarify the general layout
we stripped the drawing.
67526
Follow the instructions very carefully. The rod lengths had
been verified by experienced flyers and work fine in most
cases. Customers having experience with helicopters should
also follow the instructions in order to find a basic adjust-
ment.
The position of the mixer base
plate is exactly in the center of the
Main frame. Fix it temporarily with
some tape.
Adjust the rod length. The outer
edge of the tailrotor mixer lever
should lead through the screw as
indicated.
Screws
Tailrotor pitch lever,
bottom view
You may bore it
open, because the
steel wire has to get
passed through the
whole with casing
67513
Bowden wire sheat
Steel wire
67523
Cover
Publicité
