Publicité
Les langues disponibles
Les langues disponibles
6. Materials used:
7. Abbreviations:
ATTENTION!
Please use a metric ruler to transfer of ALL measurements. DO NOT adjust the pushrod length directly on the manual
drawing. Use ONLY numeric sizes listed in the Instruction Manual and measure the length of the pushrods by holding it
against the scale of a metric ruler.
8.
Screws:
To assemble this model you will need:
-
Hobby knife
-
Sander
-
Screwdriver (Phillips #1 and small slotted)
-
Hex wrench 1x1.5 mm - 2x2 mm - 1x2.5 mm
-
Needle nose pliers
-
Bladegauge, Order No. 603445
-
Nut driver 4mm - 4.5 mm - 5 mm - 5.5 mm
-
Bowls for small parts
-
Cyano glue
-
Screwlock, Order No. 320006
To avoid unnecessary text in the manual we shall use certain abbreviations as
follows:
Your special attention is
required!
Use cyano glue!
Assemble the shown
quantity!
Assemble the left side
the same way as the
right side.
Use some oil.
Most screws in this kit have metric threads and are described in the following way:
Different heads are used:
Caphead (CH), Lenshead (LH), Countersunk (CS), Roundhead (RH), phillips or
slotted types
M4x20 mm CH means 4 mm metric thread, 20 mm length with a cap head.
Tighten the crews very carefully. Do not use too much force and avoid damaging the
material.
Correct
Head
Diameter
Length
wrong
Use screw lock as
shown.
The subject is shown in
true scale.
The part has to move
easily without any
friction.
Assemble in the
sequence as shown.
Publicité
