iKarus ECO8 Notice De Montage page 44

2x 67542 Blade holder
1x 67549 Hub
2x 67576 Ball
2x 67566 Ball bearing 2x6x3 mm
2x 67603 M2x8 mm LK Screw
1x 67550 Tail rotor shaft
2x 67574 M3x4 mm set screw
2x 67564 Ballend, short
4x 67561 M2x6 mm LK Screw
1x 67544 Tail pitch plate
1x 67538 Collar
1x 67545 Outer slide ring
1x 67537 Slide bush
1x 67702 Pulley
2x 67571 Ball bearing 3x7x3 mm
1x 67548 Housing
1x 67551 Belt
1x 67539 Tailpipe
1x 67606 Vertical fin
1x 67546 Spacer
1x 67541 Pitch lever
1x 67633 Washer 2 mm
2x 67598 M2x14 mm CH Screw
2x 67583 M2 mm nylon nut
The belt can be passed through the tailboom
easily, when you tighten up temporarily the
belt through the clevis of the tail control snake
(in the cardboard box). After that, pull the tail
control snake through the boom.
Use cyano glue to fix the outer slide ring onto
the collar. Avoid spoiling glue to the slide
bush. The collar must move without friction.
Please watch out for the alignment of the
pushrods,while you are assembling.
Allow a small gap
between the slide
bush and the
outer slide ring.
Anticlockwise!