Publicité
Les langues disponibles
Les langues disponibles
1x
67527
Tie Rod M2x12 mm
1x
67523
Quick Link
2x
67520
Servospacer 3 or 5 mm
1x
67564
Ballend, short
1x
67531
Tie Rod M2x52 mm
2x
67565
Ballend, long
1x
67576
Ball
1x
67603
M2x8 mm LH Screw
1x
67582
M2 mm Nut
Make sure that you have a basic adjustmenst as
indicated above.
If the servo turns to the front, the left 90° lever moves
the elevator rod upwards.
The swashplate tips to the front so the helicopter starts
to bend the nose downwards
In order to obtain equal steering response to both
sides, the adjustments have to be done as shown.
Keep in mind that the pitch servo shall be installed
oposite the elevator servo so there should be some
space left. Use either the 3 mm or 5 mm Servo spacer
to adjust for the correct offset of the servos and keep in
mind that the rod never touches the main rotor shaft.
10 mm
Use a 3 or 5 mm Servo
spacer, 67520,
depending on your servo
The length may vary according to the final servo position. Make
sure that the mixer base plate is exactly in the center of the main
frame and the 90° lever is at a right angle.
67582
67564
67576
67603
View from the top.
67527
67523
abt. 36 mm
67565
67531
67565
Make sure that the rod doesn't touch the main
rotor shaft in any position. Use the 3 or 5 mm
spacer to get a suitable servo position
71 mm
Publicité
