Settings And Fuel Selection - tecnotest STARGAS Manuel D'utilisation

STARGAS _________________________________________________________________________ STANDARD TEST
6.2 -

Settings and fuel selection

•
Select the SETTINGS function (116) from the previous FUNCTIONS
BAR and on the LCD the following page is displayed.
Settings: To set the tested vehicle number of cylinders, the type of cable
122.
used to measure the rpm (induction clamp or battery cable) and the
tested engine times (2 or 4 times). The calibration of the rpm can be
carried out too, when the revolutions are measured by means of the
battery cable.
Fuel selection: To enable the type of fuel used by the tested vehicle.
123.
Select the fuel used by the tested vehicle (the default fuel is gasoline)
and press ENTER.
Autozero: To start an automatic zero of gas values.
124.
•
Select the function (122) to display the following page.
This page shows the default settings.
OPERATING INSTRUCTIONS
122
123
124
125
126
127
128
31