STARGAS ___________________________________________________________________________ DESCRIPTION
1.0 -
DESCRIPTION OF STARGAS
1.1 -
Tool front view
Lens: Infrared rays conveying filter for the remote control receiver.
11.
Memory card slot: To update and install new programs for the direct
12.
use of the Autodiagnosis and for future functions.
STAND-BY key:
13.
Slightly press the key to turn off the LCD display back-light
(sleep mode).
Press again to go back to the previously displayed function.
Hold down the key for more than 2 seconds to put the tool in the
stand-by mode.
Press the key again to reset and to take the tool back to the stand-by
position ready for the use. The function is indicated by the red colour
of the key.
ESC key: To quit the various pages of the test measurement, enabling
14.
and setting.
MENU key: To enable or disable the FUNCTIONS BAR display, or to
15.
scroll the display of many FUNCTIONS BAR in a decreasing way
(from the last to the first).
Cursor shift keys: Allow to shift selection to the four directions
16.
(low, up, right and left).
ENTER key: To confirm key.
17.
Contrast key: To decrease the contrast the LCD.
18.
Contrast key: To increase the contrast the LCD.
19.
FEED key: To feed the printer paper.
20.
Printer: It prints the test results on a ticket.
21.
F1, F2, F3, F4 and F5 keys: Press the keys when prompted on the
22.
display or to enable the FUNCTIONS BAR icons.
Display LCD: Enables the operator to follow the test phases and to
23.
read immediately the results.
OPERATING INSTRUCTIONS
11