Last Calibration Date - tecnotest STARGAS Manuel D'utilisation

STARGAS _____________________________________________________________________________ CONTROLS
If the analyser detects any impurities in the pneumatic circuit, the message is
displayed HC TEST NEGATIVE .
In this case clean the gas sampling pipe, make sure that the filters are clean
and then repeat the test.
If no impurity is detected, the message is displayed HC TEST POSITIVE .
11.6 -

Last calibration date

This function enables the user to check both the date of the last calibration
that has been carried out, and the time and the date of the last leakage and
HC residues tests.
•
Select LAST CALIBRATION icon from the CONTROLS page (see
chapter 4.1).
OPERATING INSTRUCTIONS 51