Initial Selection; Standard Test - tecnotest STARGAS Manuel D'utilisation

BEFORE THE TEST _______________________________________________________________________ STARGAS
4.1 -

Initial selection

•
Select the GAS ANALYSIS function from the APPLICATION MANAGER
page to enter the program.
•
The following functions are displayed on the LCD:
MEASUREMENT: this test includes:
OFFICIAL TEST: to carry out specific measures as required by the
concerned country standard.
STANDARD TEST: to check exhaust gases according to the
OIML CLASS 0 standard.
λ
PROBE TEST: to check the efficiency of the Lambda probe and the
correct functioning of the injection of the control unit.
CURVES: to display graphically the exhaust gas variation.
HISTOGRAMS: to display graphically the exhaust gas comparison.
EXIT: to quit the programme in any moment even by interrupting the
test if it is necessary.
•
Press the MENU key to display from the GAS ANALYSIS page the
following FUNCTIONS BAR.
Controls: To display a page where to carry out tests.
101.
Applications: To return to the page of the application programs.
102.
Help: To recall the help on line.
103.
24
101
102
103
OPERATING INSTRUCTIONS