Tool Rear View - tecnotest STARGAS Manuel D'utilisation

DESCRIPTION___________________________________________________________________________ STARGAS
1.2 -

Tool rear view

Main switch: to turn on and off the tool if plugged to the mains supply.
24.
Main switch: to turn on and off the tool if plugged to a battery.
25.
Filter-holder with internal cooling air filter that can be
26.
washed.
Short Transparent Plug: It holds the condensate separating filter.
27.
Condensate Separating Filter: It allows to separate the condensate
28.
from the exhaust gases.
Long Transparent Plug: It holds the standard cartridge/filter.
29.
Standard cartridge/filter: It allows to separate the impurities from
30.
the exhaust gases.
Certification plate: All of the technical features can be found there.
31.
COM1 Port: serial port for the connection to the autodiagnosis
32.
interface.
COM2 Port: serial port for the connection to the autodiagnosis
33.
interface.
PARALLEL port: Port for the connection to a 80-column standard
34.
printer.
Port for special activations by electronic key.
35.
RS485 port: Port for industrial standard serial connection.
36.
RPM Socket: Socket for the connection of the RPM clamp from battery
37.
or of induction clamp (option).
TEMP Socket: Socket for the connection of the oil temperature probe.
38.
Ambient
39.
(relative humidity and temperature).
λ
Socket: Socket for the connection of the lambda probe
40.
1 Volt/5 Volt.
12
sensors: Sensors to detect environment data
OPERATING INSTRUCTIONS