Print Of Results - tecnotest STARGAS Manuel D'utilisation

STARGAS _________________________________________________________________________ STANDARD TEST
6.1 -

Print of results

•
Select the PRINT function (115) from the previous FUNCTIONS BAR
and on the LCD the following page is displayed.
24-column print: To enable the print on the STARGAS printer.
120.
80-column
121.
80-column printer connected to the PARALLEL port of the STARGAS.
After selecting the type of print to be used, the LCD shows a page where to
enter identification data of the tested vehicle.
•
Enter the lic. plate number, model, brand, chassis number, run
Km and the operator name, shifting among fields by the ENTER key.
•
Select ENTER if the icon of the print-out is highlighted or F5 to start
print.
•
Select F3 to erase the previously entered vehicle data.
NOTA BENE:
In tests CURVES, HISTOGRAMS, LAMBDA PROBE the F4 function is
displayed. Press a key for the graphic print of the performed test.
ATTENTION:
In case the external printer is off line (not connected to the
STARGAS or off) the message PRINTER OFFLINE is displayed.
•
Reset rapidly the correct situation to go on printing or repeat the
operation.
OPERATING INSTRUCTIONS
print: To enables the print from
120
121
an external
29