Use Of The Stargas Keyboard - tecnotest STARGAS Manuel D'utilisation

STARGAS ____________________________________________________________________________________ USE
ATTENTION:
At the end of measurement disconnect the RPM cable from the
battery and short circuit the clamps one another to avoid the
display of a wrong rpm due to the high sensitivity of the system. If
a RPM cable from car lighter is used (option) short circuit it
through the special hook connected to it.
If during the tests with induction clamp the revolution number is unstable
(showing a trend towards anomalous values), probably some parasitic
signals or some other signals coming from the ignition system of the other
non concerned cylinders get into the induction clamp.
The reasons for these drawbacks are numerous, for instance:
•
Spark plug contacts blinked with an excessive resistance.
•
Coil high output.
•
Excessive distance of the spark plug electrodes.
•
Spark plug cables too close one another and non perfectly insulated.
•
Humidity of the cables, of the spark plugs, etc...
ATTENTION:
Check that no electrical discharges occur between the spark plug
cable and the clamp, which could seriously damage the analyser.
3.4 -

Use of the STARGAS keyboard

To set the workshop data pr any other value by means of the keyboard of
the STARGAS follow indications below:
•
Press MENU and at the same time the arrow up or down cursor
keys to select a setting (lowercase, capital letters, digits and space).
•
Press many times the arrow up cursor key to scroll letters or digits
increasingly (from A to Z or from 0 to 9).
•
Press many times the arrow down cursor key to scroll letters or digits
decreasingly (from Z to A or from 9 to 0).
OPERATING INSTRUCTIONS 19